Model # 56574142
Part # VT-4FT-3600LM-8-40K-SV-N
USE AND CARE GUIDE
4 FT. RESIDENTIAL VAPOR TIGHT LIGHT
FIXTURE
NOTE
:
Keep your receipt and these instructions for proof of purchase.
WARNING
:
Shut off the power at the circuit breaker or fuse panel before
removing the old fixture, ballast, or fluorescent tubes.
If you are unfamiliar with electrical installations, we recommend you contact a
qualified electrician to do the installation.
INSTALLATION
NOTE:
The distance between two holes is 31.4in or 800mm.
SUSPENDED INSTALLATION
：
PACKAGE CONTENTS
Part Description
Quantity
A
Fixture
1
B
Mounting Screw
4
C
Plastic Drywall Anchors
4
D
U Bracket (stainless steel)
2
E
V Clip(stainless steel)
2
F
Chain
2
G
S Hook
2
1
Installing the bracket and clip for hanging
• Insert the ends of the V clip (E) into the openings in the U bracket (D).
• Snap the U bracket (D) onto the back of the fixture body near one end.
• Repeat the installation process for the U bracket (D) and V clip (E) on the
other end of the fixture body.
A
B
C
D
E
F
G
Mounting to drywall:
• Drill two 1/4in. holes in the ceiling to clear the closed flaps of the toggle bolt (not included).
• Make sure to fasten the toggle bolt into the butterfly nut before inserting the flaps into the ceiling.
• Tighten the toggle bolt.
Mounting to wood:
• Drill two 1/16 in. diameter pilot holes in the ceiling.
• Make sure to fasten the combo wood-machine end into the metal hook.
• Tighten the hook screw (not included) into the wood.
2
Hook the V clip (E) on each end of the fixture to the metal hooks installed in the ceiling.
3
Optional suspending the fixture with chain:
• Attaching the fixture light to the chain. Install one closed loop of hanging chain (F) to the metal “S” shaped
hook (G) on the fixture body. Repeat this step on the other side of the fixture.
• Attaching the chain to the ceiling Hang the fixture body by one chain set (F, G) over each hook (not included)
that has been installed on the ceiling. Adjust chains to level light.
• Insert the plug to the power socket, and turn on the switch to activate the fixture.
4
CONTINUOUS SUSPENDED INSTALLATION
：
The continuous mounting steps are based on the suspended mounting.
• Open the end cap by screwing off the two screws, remove the waterproof connector and linking
cable, and punch out the knock out holes (0.86-inch) on the end of each end cap where the
fixtures will connect.
• Insert a type 1/2 out diameter conduit and nut through both open knock out holes.
• Insert one end of the jumper wires (not included) into the wire connectors from the first fixture,
then run jumper wires through the conduit and nut (not included), and insert the other end into the
wire connectors from the next fixture to make the electrical connections.
• Refer to the suspended installation steps to finish the suspended mounting of all the fixtures.
NOTE:
The Conduit shall comply with UL1660, UL LISTED, Liquid-
tight, suitable for outdoor use.
The conduit fitting comply with UL514B, UL LISTED, Liquid-
tight, suitable for outdoor use.
Nut: P502-1/2, E256570, Conduit: PLFNCB-1/2,E361947
Multiple light fixture can be connected, up to a maximum of
8 lights.
A
D
E
F