EBB6000 POWER BANK
INSTRUCTION MANUAL
WARNINGS
• To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.
• To reduce the risk of electric shock, do not open the cabinet. No user serviceable parts are inside.
• Do not expose to excessive heat such as direct sunlight, fire, or other heat sources.
• Do not expose to dripping or splashing liquids. Do not put objects filled with liquid on or near the device.
• Do not use the Power Bank in an airtight container while charging a device, doing so may cause
damage to equipment and/or cause personal injury.
• It is normal for the Power Bank to get warm during use, however it should not become too hot to hold.
Immediately stop using the Power Bank if you encounter burning, any discoloration or deformation of
• Immediately stop using the Power Bank if you encounter any leaking from the internal battery. If the
battery’s fluid makes contact with your skin, immediately seek medical attention.
Charging The Power Bank
Insert the supplied USB cable (Micro-USB end) to the Mobile Power Bank’s Micro-USB Input. Connect
the other end of the cable (USB Type-A) to any DC 5V/1A source (e.g. a computer’s USB port, or a
USB wall or auto charger). The Power Bank can also be charged by inserting a Type-C USB Cable
Do not force the USB Cable into the Power Bank or the Connected Charger
NOTE:
During charging, the LED Display will flash the current charge of the Power Bank from 0-100%.
•
The Power Bank is fully charged the LED Display reads 100.
Using the Power Bank to Charge Your Device*
Make sure the charging voltage of the device being charged is correct (< 5V).
Connect your device using the device’s charging cable (not included). Insert the USB type-A end into
the USB output port of the Power Bank. If your device uses a Type-C USB cable insert the Type-C end
NOTE:
The LED Display will light up during the first few seconds charging and then will turn off.
*All times and refill numbers are estimates and are dependent on device model and location of
use.
For Technical Assistance Call 1-855-994-3832 or Visit www.sibrandssupport.com
Checking the Charge Level
To check the Power Bank’s current charge, Press the Power button and then refer to the LED Display
the Power Bank or your connected device.
The charging process will sometimes take a few hours depending on how much power is left in the
Power Bank.
near the top of the unit.
(not included) into the Type-C Input/Output and a USB power source (computer port, wall/auto charger).
of the cable into the Type-C Input/Output on the Power Bank.
The LED Display will show the current charge of the Power Bank in a percentage from 0-100%
To turn the LED Display Off, either press the Power button again, or wait a few seconds and the
display will turn off automatically.
