68
SmartFade ML v3.0.1 User Manual
Default Device Times
There are two types of default device times.
•
Move Dark Time
= A limiting time that sets a maximum speed for any function, mainly
to keep mechanical noise down. This time is used by Move While Dark prepositioning
in sequence/Stack and Home.
•
Palette Time
= A time used when activating a palette or using Align.
They are both set in the Default Time menu
Menu>Setup>Default times[FCB Times]
Use encoder wheel 2 and 3 to set the times. Exit menu when done.
Memory FCB Times
A memory can have a time for the FCB parameters, that is used (only) when they are
executed with the Bump button in GO mode.
See “Memory Bump Modes” on page 83.
Step 1:
Press
EDIT
Step 2:
Press
TIME
.
Step 3:
Now press a bump button for a memory. The display will change to time setting.
Step 4:
Press
EDIT
to exit.
Test the FCB time
If you have set this time to a memory with devices and want to try it, press CLEAR 4 times
to clear the output. Set all memory faders to zero. Select all devices and set to HOME. Set
faders to INT ONLY and bring up the fader for the memory. Activate GO mode. Press the
bump button for the memory where you set an FCB time. The device parameters should
change in this time.
Menu choice
Console
Feedback
PAGE
Wheel 1
Select another fader page (or press a bump)
MEMORY
Wheel 2
Select another memory (or press a bump)
FCB TIME
Wheel 3
Set the FCB time for the selected memory
Summary of Contents for SmartFade ML
Page 46: ...38 SmartFade ML v3 0 1 User Manual...
Page 72: ...64 SmartFade ML v3 0 1 User Manual...
Page 102: ...94 SmartFadeML v2 1 User Manual...
Page 103: ......
