2
The Retrofit
11
Finish Up
Step 1:
Remove the old CEM rack door baffle from the door (outlined below) by removing
the four 5/16” nuts.
Step 2:
Install the new CEM+ rack door baffle on the rack door with the four 5/16 nuts.
Step 3:
Reinstall the rack door by
pushing down on the tab
in the hinged corner and
sliding the door back in
place.
Step 4:
Reinstall the left side of
the rack with the original
10 screws.
Change out the AF Cards (if
present)
)
Step 1:
Remove the old AF cards (pull the plastic tabs
Step 2:
Address the new AF cards (mini-switches) as
shown here.
Step 3:
Install the cards in the slots. Make sure they are
completely and securely seated. Card #1 at the
top, down to 4 at the bottom for SR48. (SR6, SR12 & SR24 have fewer cards.
Always start with #1 at the top.)
Repeat the above steps for the remainder of touring racks that are to
be retrofitted.
1-
P
u
s
h
2
-R
ei
ns
tall
Reinstall
AF Card Addressing
Card 1
Card 2
Card 3
Card 4
S
W
1
S
W
2
S
W
3
S
W
4
1 SR6+
SR12+
SR24+
SR48+
2
3
4
Summary of Contents for sensor+ CEM+
Page 15: ......
