ETC QuickTouch+ 12, User Manual

Page: 15 / 32

1
Operation 11
Control Motors
Selecting Motors
In order to control a motor (or motors) you must first select them using the select buttons on the
control station.
To select a motor press the button corresponding to the motor you wish to control. The LED for
that button will illuminate white when selected.
If you wish to control multiple motors, press the buttons for all desired motors. All selected
motors will display illuminated LEDs to indicate they are selected. The maximum number of
motors that can be operated simultaneously is set by the installer. This number is based on the
rigidity of the support structure and the physical arrangement of the motors in regard to the
control station and how many moving loads can be monitored by the operator at any given time.
To deselect a motor you may press the corresponding button again. The LED will go dim when
the motor is deselected. If all motors are deselected, the “System OK” screen will be displayed.
If more than the maximum number of motors is selected, the first motor that was selected will
deselect (then the second selected, then the third, and so on) so that the number of selected
motors never exceeds the maximum allowed number of motors.
To deselect all motors at once, press the [CLEAR] button.
Selected Motor Display
On selection of a motor, the LCD will display the status screen for that motor. If multiple motors
are selected, the status screen for the last selected motor will be displayed. For identification of
the components of this screen, see Motor Status Screen, page 9 .
Trim 2:
Speed:
300 lb
16’9”
90 fpm