ETC QuickTouch+ 12, User Manual

Page: 14 / 32

10 Qui Control Station User Manual
Activate System
Keyswitch Activation
To enable the station for motor control, use the “POWER” keyswitch.
Insert the key into the keyswitch and turn it to the “On” position.
During power up, the control system performs a complete self-test of the control station and all
connected motors. When the station has powered up completely and no malfunctions were
detected, “System OK” appears on the LCD.
Contact information
The contact information screen is shown as the system powers up. This screen displays contact
information for the installer responsible for the system or ETC’s website and phone number.
Your installer may have chosen to display their contact information. The software version is also
displayed during the start up.
By default, this contact information is displayed for 3 seconds. To prolong the display of contact
information indefinitely, press and hold [Clear] during power up. The contact information will be
displayed until any other button is pressed.
Deactivation
When you are done using your control station, or when you will be leaving it unattended for any
length of time, deactivate the station using the “POWER” keyswitch.
Turn the keyswitch to the “Off” position and remove the key. The station will be deactivated.
W A R N I N G :
Qui control stations and other ETC Rigging components should
be operated and maintained by trained personnel only.