Irideon WLZ User Manual
11
Install Canopy Fixture (0–10 V and DALI
Variants)
Note:
The 0–10 V driver conforms to IEC 60929 Annex E. Of the
0–10 V range, use 0–1 V to set the minimum level, and use 1–10 V
for continuous dimming.
Note:
The canopy fixture can be installed directly on 4 in and
4-11/16 in back boxes, or on back boxes with round cover plates.
The canopy fixture cannot be installed on 1-gang back boxes or
trim rings.
WARNING:
RISK OF ELECTRIC SHOCK! Install the cover plate
as directed below for installations where the interior of the
canopy enclosure could be exposed after installation with only
the mounting plate. For example, install the cover plate when
installing to a surface-mount back box.
AVERTISSEMENT :
Installez la plaque de protection comme
indiqué ci-dessous pour les installations où l'intérieur de la
rosace de plafond pourrait être exposé après l'installation
avec uniquement la plaque de montage. Par exemple, installez
la plaque de protection lors de l'installation sur un boîtier
arrière à montage en surface.
1.
Cover plate
(if needed
for surface-
mounting)
Mounting
plate
Mounting
plate bolts
Canopy
bolts
Remove the adhesive tape or
fasteners securing the
mounting plate to the fixture
to free the mounting plate
from the canopy enclosure.
