Maintenance
27
Maintenance
CAUTION:
RISK OF ELECTRIC SHOCK! Disconnect power before servicing.
ATTENTION :
RISQUE DE CHOC ÉLECTRIQUE! Couper l'alimentation avant
l'entretien.
Keep the following in mind during regular service and inspection:
•
All screws for installing the fixture or parts of the fixture must be tightly connected and
must not be corroded.
•
There must not be any deformations to the housing, lenses, rigging, and installation points
(ceiling, suspension, trussing).
•
Moving parts must not show any signs of wear and must move smoothly without issue.
•
The power supply cables must not show any damage, material fatigue, or sediment.
•
If spare parts are required, order only genuine parts from your local authorized dealer.
To ensure that the fixture remains in good working condition and does not fail prematurely,
regular maintenance is recommended.
Clean the Fixture
1. Clean the inside and outside of the lens regularly using a damp, lint-free cloth to avoid
loss of output due to accumulation of dust/dirt on the lens. Never use alcohol or solvents.
2. Clean the fans regularly to ensure maximum airflow and efficient cooling. This will ensure
that the light source operates in the best possible condition.
Replace the Fuse
WARNING:
Replace fuses with the specified type and rating only.
AVERTISSEMENT :
Remplacez les fusibles uniquement par le type et le
calibre indiqués.
CAUTION:
RISK OF ELECTRIC SHOCK! Disconnect power before servicing.
ATTENTION :
RISQUE DE CHOC ÉLECTRIQUE! Couper l'alimentation avant
l'entretien.
Supplies needed:
•
Flatblade screwdriver
•
One replacement fuse: 20 A 250 V 6x32 mm VDE slow-blow ceramic
A replaceable AC line fuse is provided in the fixture to prevent overload.
1. Disconnect power to the fixture.
2. Using a flatblade screwdriver, push the fuse holder in and twist it to remove it from the
fixture. (See
for the location of the fuse holder.)
3. Remove the blown fuse from the holder and replace it only with another 20 A 250 V
6x32 mm VDE slow-blow ceramic fuse.
4. Reinstall the fuse holder. Using a flatblade screwdriver, push the holder in and twist it until
it is secure.
Summary of Contents for High End Systems SolaFrame 3000
Page 35: ...Compliance 31 ...