ETC F-Drive W1 Series, Installation Manual, Page: 26 / 44

22 W1 Installation Manual
Third-Party Fixtures
The W1 CC Driver and the W1 CV Driver support a wide variety of third-party loads.
Determining compatibility between these loads and the driver is an important step toward
ensuring the success of a project. Search the
LED Dimming Compatibility Database at
etcconnect.com/compatibility to see if your load is compatible. If your load is not in the
compatibility database, follow the instructions at the link above to contact the ETC Applications
Engineering department to arrange for compatibility testing.
Third-Party constant current or constant voltage fixtures can be connected to a W1 CC Driver or
W1 CV Driver either directly to the two-pin terminal or to the RJ45 output through a B-Box4
breakout box with terminal outputs (FD-BBOX-4T) that provides four two-pin terminals.
CAUTION:
Do not exceed any Class 2 limits stated by the manufacturer of
the third-party load.
Connect Lighting by Other Manufacturers to the RJ45 Output with B-Box4
The FD-BBOX-4T takes a single four-channel RJ45 output from an FTW-150 Card or CC-150 Card
and provides four separated two-pin output channels. Visit the F-Drive System Design Tool at
etcconnect.com/Products/Power-Controls/LED-Drivers/F-Drive/F-Drive-System-Design-
Tool.aspx
and see the
F-Drive B-Box4 Installation Manual
and the
F-Drive R12 and W1 Wiring
Reference Guide
for more information.
Connect Lighting by Other Manufacturers to the Terminal Block Outputs
Refer to the
Terminal Block Pinout on page 20
.
Configure the W1 CC Driver
CAUTION:
Setting the F-Drive W1 CC Driver to output more current than
the manufacturer recommends for the loads may reduce the lifetime or cause
damage to the load.
ArcSystem Navis 100 Fade to Warm luminaires should only be connected to a
W1 Fade to Warm Driver.
The W1 CC Driver can output 200–700 mA. Output current can be configured via RDM. See
RDM Parameters on page 29 .
Default output current is 450 mA.
ETC Luminaire Current Requirement
ArcSystem Navis 100 Fixed White 600 mA
ArcSystem Pro One-Cell White or Fade to Warm 600 mA
ArcSystem Pro One-Cell Small White or Fade to Warm 600 mA
ArcSystem Pro One-Cell Micro White or Fade to Warm 200 mA