14
W1 Installation Manual
Wall-Mount the W1 Driver
W1 Drivers can be surface-mounted to any wall capable of supporting their weight using the
mounting straps. The mounting straps allow you to install the W1 Driver without removing the
cover. If you prefer to use the mounting holes in the back panel of the W1 Driver, you can
remove the mounting straps. See
.
Followe these steps to wall-mount the W1 Driver with the mounting straps.
1. Using four #10 screws, mount the back panel to the mounting surface using the mounting
straps.
•
Mount the enclosure with the mounting direction arrow pointed up (item I in the illustration
on the previous page). The text on the installed cover will be upright.
2. Remove the two screws on the cover of the driver and set them aside.
3. Remove the driver cover. The cover is tethered to the backbox. Be careful when handling.
4. Remove the four screws securing the removable wiring panel to the backbox.
•
Set the screws aside for later reinstallation.
5. Punch holes as needed for conduit for power connection and data connection.
6. Reinstall the removable panel to the backbox using the four screws removed in step 4.
7. Install Romex or nonmetallic screw-clamp conduit connectors as needed.
8. Attach flexible conduit to the driver.
Note:
•
Use suitable conduit where required by national and local codes.
•
Driver may require additional means of securement. Installation must follow all
national and local codes for electrical equipment.