Chapter 1
9
Before You Begin Installation
Review the following information before installing the F-Drive W1.
Installation Requirements
•
Ambient operating temperature 0–40°C (32–104°F), 5–95% non-condensing humidity.
•
Dry locations only.
•
Refer to the
ArcSystem Navis 100 Installation Guide
for luminaire installation requirements.
All ETC documents are available for free download from our website:
.
Power Disconnect Device
Before installation, make sure you have an accessible input power disconnect device installed
ahead of your F-Drive W1.
WARNING:
RISK OF DEATH BY ELECTRIC SHOCK! Failure to disconnect all
power to the system before installation, maintenance, cleaning, or any
other system modification could result in serious injury or death.
AVERTISSEMENT :
RISQUE DE MORT PAR DÉCHARGE ÉLECTRIQUE!
Négliger de débrancher toutes les sources d’alimentation du système avant
l’installation, l’entretien, le nettoyage ou toute autre modification du
système peut causer des blessures graves ou la mort.
De-energize main feed to F-Drive Power Control products and follow
appropriate Lockout/Tagout procedures as mandated by NFPA 70E. It is
important to note that electrical equipment such as breaker panels can
present an arc flash hazard if improperly serviced. This is due to the high
amounts of short-circuit current available on the electrical supply to this
equipment. Any work must comply with OSHA Safe Working Practices.
WARNING:
RISK OF ELECTRIC SHOCK! Circuits that are installed without
an accessible power disconnect device cannot be serviced or operated
safely.
AVERTISSEMENT :
RISQUE DE DÉCHARGE ÉLÉCTRIQUE! Il est imprudent
d'utiliser ou de réparer les circuits installés sans qu'un dispositif de
déconnexion de l'alimentation ne soit accessible.