ETC Emphasis Lighting Control System, User Manual, Page: 250 / 292

240 Emphasis Console v1.4.0 User Manual
LPC), using two 6-32x1/4” flathead screws each. Choose the bracket holes
farthest from the bend.
Step 4: Place the LPC on the mounting surface. Mark the surface through the mounting
holes in each bracket. Remove the LPC.
Step 5: Drill holes at the marks of the appropriate diameter for the mounting anchors/
screws you have provided.
Step 6: Securely attach the LPC to the mounting surface.
Install Cables
Except for the RFU connection, all cables connect to the rear panel of the Express LPC.
There is a strain relief provided for the power input cable.
Install the Express LPC power supply:
Step 1: Push the LPC unit’s power switch to the OFF position (“O” position).
Step 2: Remove the thumbscrew to free the cable clamp from the rear panel.
Step 3: Clip the cable clamp over the attached power supply cable near the 8-pin male
connector.
Step 4: Plug the connector into the LPC power input receptacle.
Step 5: Adjust the cable clamp so that you can re-attach it to the LPC.
Step 6: Plug one end of the furnished power cord into the power supply and the other
end into a grounded power outlet.
Step 7: If you require a chassis ground, connect a ground wire to the grounding screw
on the LPC rear panel.
Configuration Guidelines
You have the same configuration options for DMX input, output, and show control protocols
(MIDI and MSC) that the full Facepanel provides. These settings are described in Control
Interfaces, page 175 .
Enter the configuration menu on the Express LPC:
Step 1: Power up or reboot the LPC and turn on the monitor.
Step 2: When the prompt appears on the monitor at startup, press [M1][M2][M3] on the
touchscreen or RFU to enter the configuration menu. Once you are in the
configuration menu, use the RFU to modify configuration settings.