Cue Playback
359
For information on manual timing, see
Manual Timing Control (on page 362)
and for manual
master, see
Using [Stop/ Back]
All fader activity can be instantly stopped mid-transition by pressing the [Stop/Back] button
for the required fader. To resume the cue, press the [Go] button. To fade to the previous cue
on that fader, using default “back” timing, press the [Stop/Back] button again from this state.
When you have gone to the previous cue using the [Stop/Back] button, the cue should look
just like it did before you hit the [Go] button, if the cue still has ownership of all of its
channels. If a different cue list has taken ownership of some of the channel parameters within
that cue in the interim, those specific channel parameters will not respond to the [Stop/Back]
command.
If a cue is recorded or rerecorded when a fade is stopped, the contents of that fader will be
recorded as absolute data in the new record target. If a cue is updated with the fader in a
stopped state, all references in the cue will be updated accordingly.
When a cue on the playback fader is complete, pressing [Stop/Back] will step backwards
sequentially through the cue list from that point. [Stop/Back] uses default back time as
established in Setup, see
. Or you can back into the previous cue
using specific timing with [Go to Cue] [Last] [Time] [n] [Enter].
Using Blackout and Grandmaster
Blackout is a console function allowing you to immediately set all lighting levels to zero.
A grandmaster is type of fader that inhibits all live intensity values. Any fader on an Eos Family
console or connected wing can be configured as a grandmaster. See
for more information.
Note:
Ion Classic and Element Classic have physical grandmasters.
If a grandmaster is set to a value other than 100%, a grandmaster button with the set value
will be shown at the top of each display. If blackout is currently on, a blackout button will be
shown at the top of the displays.
Clicking on either button will open a new display which will allow you to turn off blackout and
set the grandmaster to a different level.
[Go To Cue 0]
You can use [Go To Cue 0], located with the playback controls, in conjunction with a fader
load button to send a specific cue list to cue 0. This action does not use the command line.
Simply press [Go To Cue 0] & [Load] for the desired fader.
Summary of Contents for Element Classic
