ETC Element Classic, User Manual

Page: 341 / 687

Single Cue Lists 327
When a filter has been applied, an indicator will display in the fader ribbon. C will display for
channel filter, and F is for parameter filter.
Press the red [X] to clear the channel or parameter filters listed.
Fader and Button Configuration
Click or tap on the virtual buttons or fader to see a list of available configuration options.
Button Options
The following options are available for playback buttons:
•
Go - executes the cue currently in the pending file of the associated fader.
•
Stop Back - instantly stops all fader activity. Pressing twice will fade to the previous cue
on that fader.
•
Assert - can be used to re-run the active cue on that fader, to regain control of all cue
contents, to apply a newly set higher priority state to the associated fader, or make any
changes in blind to an active cue on stage.
•
Group Select - selects the channels stored in the cue.
•
Freeze - halts all effect activity on the fader. Press Freeze again to resume effect activity.
•
Off - removes the content and if the fader is set to Master, the fader will remain where it
currently is.
•
Release - removes the content and if the fader is set to Master, the fader will reset to 0.
•
Start Stop Effect - starts the effects while ignoring dwell times. Will stop effects if any
are running.
•
Button Disabled - no action is assigned to the button.
•
Solo - plays back the content and suppresses any intensity values not provided by the
associated content while the solo button is held down. When the button is released,
intensity values are restored. Priority and HTP are ignored. Shielded, park and pixel
mapping outputs are not affected by the solo button. This is unrelated to
Solo Mode .
•
Back - fades to the previous cue.
Fader Options
The following options are available for a playback fader:
•
Master - fader will be a proportional master, a manual master, or an intensity master,
depending on the cue list property.
•
Effect Rate - fader centers to home. It controls the rate of any running effects (same
behavior as using rate via the Effect Status Display). The adjusted setting from this
control cannot be stored.
•
Effect Size - similar to Effect Rate but for effect size.
•
Rate Master - homes to center. It adjusts the cue rate, just like rate and load.
•
Down Fade - same as the default behavior of the master option.