Common Tasks
41
Restoring Rack Defaults
Restoring rack defaults is a fast way to completely reset all rack settings back to their original state. This
feature is only intended for users with touring or portable racks where a complete reset is a common
requirement.
Restoring defaults on an installed rack is not recommended unless you are expressly told to do so by
ETC Technical Services.
To restore the factory defaults to your CEM3:
1:
Save a backup of the rack configuration (see
).
2:
Press and hold [Setup].
3:
Tap [Reset], found in the upper left corner of the CEM3 interface.
4:
Continue holding [Setup] until the Deep Clear screen appears.
5:
Select Yes to clear all rack settings and restore the factory defaults, or select No to cancel.
CAUTION:
Restoring rack defaults will erase all rack data. Do not perform this procedure
unless you absolutely intend to restore the rack back to its original factory
settings.
