ETC Installation Guide
ArcSystem Pro Multi-Cell
ArcSystem Pro Multi-Cell
Page 15 of 24
ETC
Installing 100–277 V Emergency Multi-Cell Fixtures
Instructions for installing 100–277 V emergency fixtures are below. See
Multi-Cell Fixtures on page 10
for instructions on installing 100–277 V standard fixtures.
Two-cell
fixture
Four-cell
square fixture
Four-cell
linear fixture
Eight-cell
fixture
A
C
B
C
B
A
A
A
C
B
D
C
B
D
A wiring compartment
B
conduit entry for 1/2 in conduit
C DMX in and thru
D knockout for 1/2 in conduit
With the exception of power input terminations, ArcSystem 100–277 V emergency system
installation requirements are the same as those of ArcSystem 100–277 V non-emergency systems.
Complete the installation as follows, referencing these sections for installation details:
1.
Complete the steps of
Installing 100–277 V Multi-Cell Fixtures on page 10
.
2.
Install conduit hardware at the knockout or second hole in the side of the wiring
compartment.
Note:
Use flexible metal conduit when installing and focusing 277 V Emergency Pro Multi-
Cell fixtures.
