ETAS FlexRay ES920.1, User Manual, Page: 33 / 44

ES920.1 - User’s Guide 33
ETAS Technical Data
Additional information about the recycling program of ETAS GmbH is available
from the ETAS sales and service locations (see chapter 9 on page 40).
6.6 Use of Open Source Software
The product uses Open Source Software (OSS). This software is installed in the
product at the time of delivery and does not have to be installed or updated by
the user. Reference shall be made to the use of the software in order to fulfill
OSS licensing terms. Additional information is available in the document "OSS
Attributions List" at the ETAS website
www.etas.com .
6.7 System Requirements
6.7.1 Hardware
To operate the modules, an ES910 Rapid Prototyping Module is necessary.
6.7.2 Software
ES920.1 mounted in the ES910.2
To configure the ES920.1 mounted in the ES910.2 and for control and data
acquisition, you need software in the following versions and higher:
Note
Operating the ES920.1 is possible in the extension slot of the ES910.2 and the
ES910.3-A.
Support in
Application Software
Application Classifica -
tion
1)
HSP INCA INTECRIO ASCET-RP
FlexRay-IO RP V5.1.1 no V2.1 V6.1
3)
FlexRay Monitoring MC V8.1.0 V6.2.1
2)
no no
XCP on FlexRay MC V8.1.0 V6.2.1
2)
no no
1)
: RP: Rapid Prototyping, MC: Measurement and Calibration
2)
: INCA V6.2.1 with Hotfix 13 and additionally INCA-ES9xx Add-On V6.2.2
and INCA-FlexRay Add-On V6.2.3 and higher
3)
: with HSP V8.1.0 and higher