ES920.1 - User’s Guide
22
ETAS
Getting Started
5
Getting Started
The “Getting Started” chapter contains a description of how to install the
ES920.1 in and remove it from the ES910 module, the applications, wiring, con
-
figuration and notes on troubleshooting for the ES920.1.
5.1
Assembly
The extension slot on the front of the ES910 has a removable front panel. You
have to replace this front panel with the ES920.1 module if you want to use the
FlexRay channels.
5.1.1
Removing the Front Panel of the ES910 Extension Slot
To install the ES920.1 in the ES910, you need a flat-bladed screwdriver (width of
edge 2 mm).
To remove the front panel of the ES910 extension slot:
• Switch off the power supply to the ES910 module.
• Make sure that all devices connected to the module
with cables are powered off.
• Place the ES910 on a solid surface.
CAUTION!
Some components may be damaged or even destroyed by
static discharge!
Leave the module in its transport package until you want to install it.
The module should only be taken from its package and installed at a
working place that is protected against static discharge.
CAUTION!
Damage to the ES910 possible!
The ES910 module must not be stood on its back when removing the
front panel.
The mounting screws of the extension slot must not fall into the mod
-
ule.