ETAS ES584.1, User Manual

Page: 14 / 56

ES584.1 – User’s Guide 14
ETAS Hardware Description
Together with the application software INCA and ODX-LINK from ETAS permits
the ES584.1 access to the CAN and LIN bus for measurement, calibration and
diagnostics.
The ES584.1 can be connected to a vehicle's CAN bus via the diagnostics service
interface.
When validating the vehicle diagnostics, the module can be used together with
ODX-LINK, the INCA add-on for ECU diagnostics, as an interface for OBD-on-
CAN, as well as to read and delete diagnostics error codes (DTCs). A separate
diagnostic service tool is not required in these cases.
The ES584.1 module offers an open SAE J2534-compliant pass-through inter-
face for vehicle diagnostics and flash programming.
The module supports all protocols used by INCA, such as CCP, XCP, KWP-on-
CAN and UDS. The CCP and KWP-on-CAN (ISO 14230/ISO 15765) protocols are
only supported in classic CAN mode.
The costs for installation and configuration of the affordable module are mini-
mal, and an external voltage supply is not required.
3.2 Application Areas
The ES584.1 can be used for the following tasks:
• Recording and capturing communication data
• Calibration of ECUs via the CAN FD bus interface
• ECU diagnostics via the CAN bus interface and J2534 pass-through inter-
face
• Vehicle diagnostics and reprogramming via a J2534 pass-through inter-
face using application software from third-party providers
• Flash programming of ECUs
• Connection of ETAS ES3xx modules, as well as modules from third-party
manufacturers, to the INCA PC via their CAN interface (e.g. Ipetronik or
csm modules)
• Integration of the module into the BUSMASTER open source software or
via EBI-IP into application software from third-party manufacturers