ETAS ES5371.1, User Manual

Page: 8 / 34

ES5371.1 Carrier Board for ES443x Load Boards - User’s Guide 8
Introduction ETAS
The signal I/O lines of the ES443x boards are routed over the 25-pin D-Sub con-
nector. The WAGO PicoMAX 5.0 female connector can be used to apply the
+UBatt or –UBatt voltages. The status of the signals BN[0…5], SPI and JTAG is
routed between the ES5371.1 and the ES443x board via the interface and then
to the ES5300.1-A backplane connector.
To protect the UBatt voltage, there are two fuses on the ES5371.1. The ES4435.1
Current Source Load Board is protected against the polarity of the UBatt voltage
being mistaken.
1.2 Basic Safety Instructions
Please adhere to the safety instructions in this manuals to avoid injury to yourself
and others as well as damage to the device.
1.2.1 Labeling of Safety Instructions
The safety instructions contained in this manual are shown with the standard
danger symbol shown below:
The following safety instructions are used. They provide extremely important
information. Please read this information carefully.
1.2.2 General Safety Information
Please read the following safety instructions to avoid injury to yourself and others
as well as damage to the device.
ETAS GmbH cannot be made liable for damage which is caused by incorrect use
and handling and not adhering to the safety instructions.
CAUTION!
The ES5371.1 Carrier Board for ES443x Load Boards is not protected
against the polarity of the UBatt voltages being mistaken!
CAUTION!
indicates a low-risk danger which could result in minor or less serious
injury or damage if not avoided.
WARNING!
indicates a possible medium-risk danger which could lead to serious
or even fatal injuries if not avoided.
DANGER!
indicates a high-risk, immediate danger which could lead to serious
or even fatal injuries if not avoided.
Note
Please read this User’s Guide carefully before using the product.