ETAS ES5340.2, User Manual, Page: 16 / 120

ES5340.2 Electric Drive Simulation Board - User’s Guide 16
Introduction ETAS
Requirements for the Installation Location
Requirements for Ventilation
Transport and Installation
Connecting/Disconnecting Devices
To avoid injuries and hardware damages, please observe the following precau-
tionary measures:
• Do not apply any voltages to the connections of the product that do not
correspond to the specifications of the respective connection.
• Do not connect or disconnect any devices while the ES5300.1-A Housing,
the ES5300.1-B Housing or connected devices are switched on. First,
switch off the ES5300.1-A Housing and the ES5300.1-B Housing by shut-
ting down the real-time PC and by pressing the On/Off switch at the rear,
then unplug the power cable.
• When plugging in connectors, ensure that they are inserted straight and
no pins are bent.
WARNING!
This is class A equipment. This equipment can cause radio interfer-
ence in residential areas. Should that be the case, the operator may
be requested to institute reasonable measures.
CAUTION!
The air circulation inside the ES5300.1-A Housing and the ES5300.1-
B Housing can only be maintained if all free slots are covered with
front plates. Otherwise, it may lead to overtemperatures and trip the
overtemperature protection of the ES5300.1-A or the ES5300.1-B.
For this reason, install front plates in all free slots!
CAUTION!
Some components of the product can be damaged or destroyed by
electrostatic discharges. Leave the plug-in board in its transport pack-
aging until it is installed.
Only remove, configure and install the product at a workplace that is
protected against electrostatic discharges.
CAUTION!
In order to prevent damage to the plug-in boards and the LABCAR
Housing, and thereby also avoid damage to property or health,
observe the installation instructions and information contained in the
relevant User's Guides.