ETAS ES5340.2, User Manual

Page: 15 / 120

ES5340.2 Electric Drive Simulation Board - User’s Guide 15
ETAS Introduction
Electrical Safety and Power Supply
Observe the regulations applicable at the operating location concerning electrical
safety as well as the laws and regulations concerning work safety!
Power Supply
The product is powered by the ES5300.1-A Housing or the ES5300.1-B Housing
via the PCIe slot on the main board of the RTPC.
Insulation Requirements for Lab Power Supplies to Circuits Connected to the HIL
System:
• The power supply to live circuitry must be safely isolated from the supply
voltage. For example, use a car battery or a suitable lab power supply.
• Only use lab power supplies with dual protection for the supply network
(with double/reinforced insulation (DI/RI)). This requirement is met by lab
power supplies that comply with IEC/EN 60950 or IEC/EN 61010.
• The lab power supply must be approved for use at a height of 2000 m and
in ambient temperatures of up to 40 °C.
De-Energizing a Plug-In Board
Switch off the ES5300.1-A Housing or the ES5300.1-B Housing and external
power supplies, and unplug the power cable and other plug connectors attached
to the plug-in board. Wait at least three minutes before removing the plug-in
board.
Approved Cables
The signal lines must not exceed a maximum length of 3 m.
WARNING!
Fire hazard!
Only use fuses that comply with the specification in the User's Guide
for the product. Never bridge defective fuses!
Failure to observe the fuse specification can lead to excess currents,
short circuits and fires.
WARNING!
Fire hazard!
Use only approved cables for creating cable assemblies (e.g. for con-
necting the ECU and external loads). The cables used must, in partic-
ular, be suitable for the currents, voltages and temperatures which
occur and must be flameretardant in accordance with one of the fol-
lowing standards IEC 60332-1-2, IEC 60332-2-2, UL 2556/
UL1581VW-1!