ETAS
ES413.1 - User’s Guide
47
5.6.2
Daisy Chain Ports (“IN”, “OUT”)
Wiring goes from the first module towards the end of the module chain.
To wire the first module with the following module
1. Connect an Ethernet cable to the “OUT” port of the first mod
-
ule.
2. Connect the Ethernet cable to the “IN” port of the next module.
or
If two modules are connected mechanically, connect their
adjacent “IN” and “OUT” ports to the ES4xx_BRIDGE.
Fig. 5
-
14
ES413.1 with ES4xx_BRIDGE
3. Continue to wire or connect further modules as described
above.
To wire the first module with the PC and the power supply
1. Connect the combined Ethernet and power supply cable to the
“IN” port of the ES413.1.
2. Connect the RJ-45 connector to the free Ethernet interface
port of your PC.
3. Connect the supply voltage connector of the combined Ether
-
net and power supply cable to the desired power supply.
Note the color coding of the connectors.
CAUTION
The ports of the modules or the ES4xx_BRIDGE can be damaged!
Connect the modules together without getting them off-thread.