ETAS
Getting Started
ES411.1 - User Guide
45
Connecting with Additional Modules
Connecting the ES400 module with additional modules requires a 2-mm hex
key (minimum length 20 mm).
Connecting with additional modules:
1. Connect additional modules according to the procedure
described in chapter 6.2.2 on page 39
.
Connecting the ES4xx Angle Bracket with the DIN Rail
Connecting the ES4xx Angle Bracket (left) with the DIN rail
1. Place the ES4xx angle bracket onto the DIN rail.
2. Insert the hooks of the ES4xx angle bracket into the upper part
of the DIN rail.
3. Engage the ES4xx angle bracket in the DIN rail by pressing on
the ES4xx angle bracket or the module.
The module connected with the ES4xx angle bracket is fas
-
tened to the DIN rail.
6.2.5
Attaching ES400 Modules to Other Components with
Screws
Here, you connect the ES400 module to the component using two additional
M3 screws which are screwed into the drill holes of the component. The inte
-
grated assembly elements of the module are not used.
Fig. 6
-
10
Attaching to Other Components Using Additional Screws
NOTE
Additional modules can only be screwed onto the right side of this module,
but not any module blocks.
