ETAS
ES411.1 - User Guide
35
5.6
ES411.1 - DocumentConfiguration
The configuration of the ES411.1 is performed entirely via the GUI within INCA.
The configuration of the individual channels is saved either in INCA or in the
individual ES400 modules. In the first case, you can prepare settings for spe
-
cific measure tasks, e.g. in the lab. The second case is of interest to users who
share a test carrier with a corresponding ES400 test setup. In this way, several
users can call up the saved configuration directly from the modules.
5.7
Tool Integration
The ES400 modules can be selected and configured in INCA and support the
open protocol XCP-on-Ethernet. This enables easy integration of the modules
into other measure software.
The measure system can be connected directly to the PC’s Ethernet port. No
additional devices or interface converters are necessary.
5.8
Firmware Update
The firmware of the module can be updated by the user so that future versions
of the module can also be used. The firmware update is done with the help of
the service software "Hardware Service Pack" (HSP) from the connected PC.
5.9
Calibration
A calibration service for this product is available. Calibrate this product on a
regular basis to ensure reliable accuracy of the measured values.
The seal of approval on the product shows the date of the last calibration. In the
calibration certificate you will find information on the measurement accuracy.
Please contact your local ETAS representative for information on obtaining the
calibration service (see chapter “Contact Information” on page 107). For infor
-
mation on ordering the calibration service, refer to chapter “Calibration” on
page 105.
NOTE
During a firmware update, neither the voltage supply nor the Ethernet connec
-
tion may be interrupted!
NOTICE
ETAS recommends a calibration interval of 12 months.
