57
Operation PC 20 to 32 kW
2011-12
Remote Control Functions not available via remote control
Functions not available via remote control
For safety reasons, some commands can only be
executed at the boiler itself
With remote control, you can control the boiler as
if you were standing right in front of it.
However, for safety reasons, some
parameters
and functions are unavailable remotely
. These
can only be executed when somebody is by the
boiler itself. This also prevents somebody else from
activating a drive remotely while an error is being
fi xed or maintenance work is being carried out.
For example, none of the drives (stoker, ash screw
etc.) can be set to manual operation using remote
control.
Remote control must
always be set to
"Off"
or "Only View"
before rectifying errors or
performing maintenance work
(see page 14).
Note on blocked parameters/functions
If a blocked command is selected while remote
control is active, a notice window will appear.
If no buttons are pressed, this notice window
automatically disappears after 4 seconds.
If the
"Only View” mode is selected,
using remote control, the ETA customer service
is able to monitor and provide assistance, for
example, but is unable to make changes.
In
"Off" mode, remote control is
switched off. Remote display of the touch screen
is therefore not possible.
Modifying parameters
Do not modify parameters unless you know
what their function is.
Read the corresponding
section of the operating instructions before making
any modifi cations. If the explanation of the
relevant function given in the instructions is not
suffi cient for your purposes,
contact a technician
.
Switching remote control back on
Tap the remote control icon on the touch screen.
A window appears:
"On"
is the only available option.
"Only View" mode can only be selected when
remote control is "On".
Functions not available via remote control
performing maintenance work
(see page 56).