eta ePE-K 140, Installation Manual, Page: 53 / 84

Installation Filling the heating system
53
Installing the pellet hoses on the pellet hopper
On the ends of both pellet hoses, free around 10 cm of
the copper wire strands from the hoses.
Fig. 9-50: Exposed copper wire strands
Push the two pellet hoses onto the connections and
secure them with hose clamps.
Fig. 9-51: Connections on the pellet bin
Connect the copper wire strands from both pellet
hoses to the yellow-green earthing cable (next to the
connections).
Fig. 9-52: Connecting the copper wire strands to the earth
Mounting the pellet hoses on the discharge
On the ends of both pellet hoses, free around 5 cm of
the copper wire strands from the hoses. Bend the
copper wire strand inside the pellet hose.
Fig. 9-53: Copper wire strands
Push the two pellet hoses onto the connections and
secure them with hose clamps.
9.12 Filling the heating system
Filling the heating system
Fill the heating system with softened water, refer to
chapter
7.3 "Water hardness" .