–
The flat spraying jet may be separately used on steam nozzle
A4
, attached to the
extension hose
B1
, or with the accessories
B3a
/
B3b
put on.
How to assemble the accessories
Extension hose B1, concentrating nozzle B2 and flat spraying nozzle B3
All 3 adaptors can be mounted on the steam nozzle
A4
(or nozzle
B2/B3
on hose
B1
)
by putting it on and securing it by clockwise rotation (see Fig. 2). Apply a reverse
procedure to remove.
Accessories B4-B5
They can be simply mounted on the extension hose
B1
, concentrating nozzle
B2
, or steam
nozzle
A4
by putting them on. Apply a reverse procedure to remove.
Squeegee for windows and flat surfaces B3a, and textile sleeve B3b
Put the squeegee
B3a
on the flat spraying nozzle
B3
according to Fig. 3A, hooking the
squeegee bottom hooks in the bottom lugs of the flat jet, and secure in place. To remove
the squeegee, you have to move aside the protrusion on its top side, and remove the
adaptor by tilting it out. Fix the textile sleeve to the flat nozzle be putting it on (Fig. 3B).
Water filling/adding
When filling the water before use, make sure that the appliance is not connected to the
mains. Unscrew the safety pressure valve
A3
by rotating it anti-clockwise.
Carefully fill the
inside tank with water, using the attached water filling container
C
and funnel
D
. Do not
exceed the maximum permitted volume of water (i.e. 220 ml). Apply reverse procedure to
properly screw the safety pressure valve
A3
in, and tighten it using a reasonable force.
If you want to add water during operation,
it is necessary to eliminate the internal
pressure in the water tank first
. Disconnect the power cord from the mains and release
the residual pressure, until the steam stops coming out.
Let the appliance cool down for
at least 5 minutes, and then unscrew the safety pressure valve. Pour water in the open
appliance, and screw the valve in place.
Attention
–
Release of the excessive pressure and the appliance cool down are important steps,
because the pressure and the temperature in the tank are high also after disconnecting
the appliance from the mains. This means if you pour cold water inside the hot tank
immediately after opening it, there is a risk of scalding from evaporation of the added
water.
IV. STEAM CLEANER USE
The appliance becomes active and starts heating the water in the tank once you connect
it to the mains. Connection to the mains and tank water heating is indicated by the red
operation indicator light
A5
. Steam will be ready for cleaning in about 3 minutes. The ready
status is indicated by turning off the indicator light
A5
.
To activate the steam, you must first move the safety catch
A2
preventing unwanted
on-switching by your finger, and then press the steam release button
A1
.
24
GB
/ 43
