The remote control menu <Programming>
Doc. no. BA012497_02
67 / 107
GB
8.12 Detector LED on/Detector LED off
The LEDs in the presence detector sensor head show the status of the pres-
ence detector. This function is activated by default. It can be switched on
and off via the remote control. The LED signals are:
•
The red LED flashes when commands are received from the remote
control.
• The blue LED lights up when the Light Control Box is in programming
mode.
•
The green LED flashes when the detector detects movement.
You can deactivate the green LED to stop it flashing every time motion is
detected.
Deactivating the green LED in the sensor head:
1.
Select the <Programming> menu item and confirm the selection with
the
button.
2. Enable programming mode by pressing the
button.
3. Select the
button to choose the menu item <Detector LEDs off>
and confirm the selection with the
button.
4. End programming mode by pressing the
button.
The green LED switches off.
Activating the green LED in the sensor head:
1.
Select the <Programming> menu item and confirm the selection with
the
button.
2. Enable programming mode by pressing the
button.
3. Select the
button to choose the menu item <Detector LEDs on>
and confirm the selection with the
button.
4. End programming mode by pressing the
button.
The green LED switches on.
8.13 Light value on/Light value off
In order to function correctly, constant lighting control relies on information
about the current level of brightness. If lights with additional light sensors
are connected, the light sensors transmit the levels of brightness to the
Light Control Box. The external DALI detector then acts as a presence de-
tector and as a receiver for infrared commands from the remote control.