The remote control menu <Programming>
Doc. no. BA012497_02
60 / 107
GB
The DALI interface is displayed with the current light channel
number.
5. Use the
or
button to choose the light channel to which you
wish to assign the DALI interface. Confirm the selection with the
button.
6. End programming mode by pressing the
button.
The DALI interface is now assigned to the desired light channel.
8.6 DALI switch
You can configure DALI switches 1 and 2 under the DALI switch menu
item. The settings options for DALI switch 1 and 2 are identical.
8.6.1 DS1/DS2 connected
This function allows the Light Control Box to send control commands. By
default,
DS1/DS2 connected
is active. As such, you only need this function
if you have disabled the command output using the function
DS1/DS2 not
connected
.
Activating the output of control commands to DALI switch 1 or 2:
1.
Select the <Programming> menu item and confirm the selection with
the
button.
2. Enable programming mode by pressing the
button.
3. Select the
button to choose the menu item <DALI switch> and
confirm the selection with the
button.
4. Press the
button to select the DALI switch that you wish to regis-
ter as connected. Confirm the selection with the
button.
5. End programming mode by pressing the
button.
The selected DALI switch is now registered as connected.
8.6.2 DS1/DS2 not connected
This function disables the output of control commands to a DALI switch.
If this setting is enabled, you can no longer temporarily switch the DALI
switch on or off in the functions menu.
Disabling DALI switch 1 or 2:
1.
Select the <Programming> menu item and confirm the selection with
the
button.
DALI Switch
DS1 connected
DS1 not connected
DS1 off delay time
DS1 Mode
DS2 connected
DS2 not connected
Bat ok LS
ELC