Settings via the 230 V button
Doc. no. BA012497_02
100 / 107
GB
14 Settings via the 230 V button
Switch actuations are not transmitted to other Light Control Boxes via
DALI. If you want to trigger multiple Light Control Boxes connected via
DALI with a single switch, you must connect the switch in parallel on the
Light Control Boxes.
14.1 Button S1
The lighting can be switched on or off or dimmed using the S1 button.
14.1.1 Switching the lighting on/off
Switching the light on or off:
Prerequisites:
• The brightness is below the set target brightness
Press the S1 button.
Depending on the previous status, the lighting switches on or off.
The Light Control Box switches to normal operation mode when
the button is pressed. If the brightness is above the target bright-
ness, the light switches off again shortly after pressing the button.
14.1.2 Dim lighting
Adjusting the dimmer in one direction:
Prerequisites:
• The lighting is switched on.
Press and hold the S1 button.
Lighting is dimmed.
The dimming process is interrupted as soon as you release the
button.
The Light Control Box enters override mode during the dimming
process, which means the setting is not permanently saved.
Adjusting the dimmer in the other direction:
Prerequisites:
• The lighting is switched on
Press and hold the S1 button.