GB
36 / 44
MA01708100
Settings with the ESY Control app
Setting options: < Standard > < slightly reduced sensitivity >
< reduced sensitivity > < strongly reduced sensitivity >
Acknowledgement:
The lighting switches on. The detector LED provides
various feedback signals during transmission. After the changes have been
completed, the green detector LED flashes three times to confirm this.
The lighting then switches off.
For the MD 230° / MD 280° models, you can also limit the field of
detection of specific segments individually and activate / deactivate
crawl protection.
Setting options: < 0 % > < 25 % > < 50 % > < 75 % > < 100 % >
Acknowledgement:
The lighting switches on. The detector LED provides
various feedback signals during transmission. After the changes have been
completed, the green detector LED flashes three times to confirm this.
The lighting then switches off.
7.2.7 Detector LED on / off
The motion detector features a detector LED behind the lens, which
provides information about the status of the device. The illumination
of the detector LED as a form of LED feedback can be switched on or
off in standard operating mode. However, this cannot be done during
the configuration. The colours of the detector LED have the following
meanings:
Green
Setting / configuration modified
Blue
Programming mode
Red
Motion detection, warm-up phase, incorrect password entered
Violet
Infrared signal transmission
Turquoise Test mode
Setting options: < On > < Off >
Acknowledgement:
The lighting switches on. The detector LED provides
various feedback signals during transmission. After the changes have been
completed, the green detector LED flashes three times to confirm this.
The lighting then switches off.
