Estun E200PS, Operation Manual, Page: 14 / 21

E200PS Operation Manual
12
The description of the PROGRAM parameters is as shown in Table 3-2.
Table 3-2 The description of the PROGRAM parameters
Parameter Default Range Unit Description
ST 0 0~25 - The total number of steps in this program.
PP 0 0~99999 -
The number of processing workpiece in this
program.
CP 0 0~99999 -

PP=0: this value is the current work
piece.

PP>0: this value is the remain work
piece.
Step 4 After finishing the setting of the PROGRAM page, press to enter STEP page,
as shown in Figure 3-5.
[Operation Guide]:
 It automatically makes the step number, according to the value of parameter ST on the
PROGRAM page.
 Please pay attention the sequence of the step, e.g. 1 / 3ST : 1 indicates the current step,
3 indicates the total step. The machine will run in sequence.
 Press to enter each step page for editing.
 Press to select the parameter you want to modify, input the value and press
to finish the operation.
 Press back to PROGRAM page.
PROGRAM2
1 / 3ST
:DestPos Of Axis X
X= 10.00 G = 10.00
XP: 50.00 mm
GP: 2.00 mm
DX: 50.00 mm
Cut Length: 0 %
Repeat Times: 1 TIMES
Figure 3-5 The STEP page
The description of STEP parameters is as shown in Table 3-3.
Table 3-3 The description of Step parameters
Parameter Default Range Unit Description
XP 0.00 -9999.999~9999.999 mm/inch
Program position of
X-axis.
GP 0.00 0~99.99 mm/inch
Program position of
G-axis.
DX 0.00 0~9999.999 mm/inch Retract distance of X axle.