FIN
FIN
FIN
FIN
UPPER TUBE MARKING GUIDE
MATCH LINES
ESTES® INDUSTRIES
1295 H Street
Penrose, CO 81240
PRINTED IN CHINA
www.estesrockets.com
PARTS:
Locate the parts shown below and lay them
out on the table in front of you.
DO NOT USE THIS DRAWING TO
ASSEMBLE YOUR ROCKET.
ASSEMBLY TIP:
Read all instructions
before beginning work on
your model. Make sure
you have all parts and
supplies.
KEEP FOR FUTURE REFERENCE.
FLYING MODEL ROCKET KIT INSTRUCTIONS
EST 2054/1245
TEST-FIT ALL PARTS
TOGETHER BEFORE
APPLYING ANY GLUE!
If any parts don’t fit properly, sand
as required for precision assembly.
Die Cut Card Fin Conduit (1) (32907)
Centering Ring Card (1)
(30126)
Die Cut Balsa Sheet (2) (32216)
Operation Enduring
Freedom sticker (1)
(60586)
SUPPLIES
In addition to the parts included in the kit you will also need:
SCISSORS
PENCIL
RULER
FINE
SAND PAPER
(#400-600 GRIT)
CARPENTER’S
GLUE
MASKING
TAPE
SPRAY
PRIMER
WHITE
SPRAY PAINT:
OLIVE
DRAB, LT. GREY
PLASTIC
CEMENT
MODELING
KNIFE
SPRAY
DULL
COAT
RAZOR SAW
SILVER PAINT
PEN
Upper Body Tube BT-55
(1) (30375)
Main Body Tube BT-55
(1) (30374)
Assembled 12” (30 cm)
Parachute
(1) (35801)
Engine Hook (1)
(35021)
Clay Weight (1)
(85704)
Red Tube Coupler (1)
JT-55 (30175-5)
Decal Sheet (1) (60554)
HELPFUL HINT: IF NOSE CONE/COUPLER FIT IS. . .
TOO
TIGHT
TOO
LOOSE
ADD
MASKING TAPE.
SAND FOR FIT.
Shock Cord (1)
1/8" x 18"
(38374)
Mylar Retainer
Ring (1)
(30168)
Green Engine
Block (1)
(30162-2)
Yellow Spacer Tool (1)
(35003)
Nose Cone (1)
(60552)
Plastic Tail Cone and
Adapter (1)
(60568)
Launch Lug (1)
(38175)
SHOCK CORD
MOUNT
SECTION
3
SECTION
2
SECTION
1
Engine Mount Tube
BT-20 (1) (30327)
FIN
FIN
FIN
FIN
LAUNCH
LUG
LOWER TUBE MARKING GUIDE
SHOCK CORD
MOUNT
SECTION
3
SECTION
2
SECTION
1
