OPERATOR’S
MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
Page
3-15
November 19, 2009
BUILDING A ROUTE VIA AIRWAY INSERTION
When no custom route is available, a route can be created by first defining the origin and destination airports on
the ROUTE page, followed by entry of the individual airway identifier on the ROUTE page.
1. Key the departure airport identifier into the scratchpad and move it to the ORIGIN field by pressing LSK 1L.
"MOD" status is displayed in the title line. The "ERASE" prompt is displayed at LSK 6L and the EXEC
annunciator illuminates.
2. Key the destination airport identifier into the scratchpad and move it to the DEST field by pressing LSK 1R.
3. Display the RTE x 2/X page by pressing [NEXT].
4. Key the identifier of the first waypoint into the scratchpad and move it to the TO location by pressing
LSK 1R.
DIRECT is displayed below VIA, indicating that the first flight leg will be from Present Position direct to the
first waypoint of the desired airway.
5. Key in the airway identifier and move it to the airway field by pressing LSK 2L, a box data field appears
against LSK 2R.
6. Key in the next airway identifier and move it to the airway field by pressing LSK 3L, the waypoint at the
junction of the two airways appears in the box data field against LSK 2R and a box data field appears
against LSK 3R.
1 R
2 R
3 R
4 R
5 R
6 R
MOD
RTE 1 2/3
V I A T O
LACRE3 HUMPP
- - R O U T E D I S C O N T I N U I T Y -
J20 OCS
J154 RAMMS
DIRECT GWENS
O F F S E T
<
ERASE
R0.0
N M
1 L
2 L
3 L
4 L
5 L
6 L
This page is printed under user's responsibility
and must not be retained for reference
