OPERATOR’S
MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
Page
3-10
November 19, 2009
ACTIVE ROUTE SELECTION USING THE CUSTOM ROUTE NAME
Display the RTE 1/X page by pressing the [RTE] function key.
1. Key in the custom route identifier into the scratchpad, e.g.: KSEAPANC1.
2. Move the custom route name to the CO ROUTES field by pressing LSK 3R.
"MOD" status is displayed in the title line. A "!WAIT" advisory message appears in the scratchpad while the
route information is being extracted from the navigation database.
3. Verify the ORIGIN and DEST identifiers.
4. Enter flight number into the scratchpad. Move to the FLT NO field by pressing LSK 2R.
5. Accept the new active route by pressing [EXEC].
"MOD" status in the title line changes to "ACT". The selected route is now active.
NOTE: With an ELBIT, EURONAV, or EURONAV_A702 DMAP configured, the CMA-9000 FMS will
automatically display the RTE x LEGS 1/X page if valid DMAP waypoints are received and DMAP
APPEND mode is ON. If the DMAP APPEND mode is OFF and valid DMAP waypoints are
received, the DMAP WPT page will be displayed. The DMAP APPEND prompt appears on the RTE
1/X page only if a DMAP (ELBIT, EURONAV, or EURONAV_A702 type only) is configured.
NOTE: When loading a custom route in flight, the CMA-9000 FMS will append a "+" to the custom route
identifier on the RTE page thus indicating that the custom route has been appended to the end of the
current flight plan.
When a custom route is inversed, the route name is preceded by the prefix INV in reverse video.
1 R
2 R
3 R
4 R
5 R
6 R
MOD
RTE 1 1/3
O R I G I N D E S T
KSEA PANC
R U N W A Y F L T N O
----- KL007
D M A P A P P E N D R O U T E
>
OFF KSEAPANC1
<
ERASE RTE1
CO ROUTES
>
<
BACKTRACK USER ROUTES
>
O F F S E T
<
RTE 2
R0.0
N M
1 L
2 L
3 L
4 L
5 L
6 L
This page is printed under user's responsibility
and must not be retained for reference
