OPERATOR’S
MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
Page
11-12
November 19, 2009
SEARCH PATTERN IN THE INACTIVE ROUTE
The same steps can be applied for the insertion of the search pattern procedures in the inactive route. Press
<DES+SAR> or <TACTICAL> [NEXT] to access the INACT DES+SAR or TACTICAL 2/2 page. These steps
relate to the inactive route pages:
RTE y 1/X and RTE y LEGS 1/X.
NOTE: The insertion of a search pattern in an inactive route is disallowed when the active route is being
modified. Data entry advisory message “!ACTIVE ROUTE IN MOD” is displayed in this case.
SEARCH PATTERN AT AN OFF-ROUTE WAYPOINT
Key in a valid off-route waypoint identifier followed by
"
/S
"
into the scratchpad (e.g.: AAA/S).
NOTE: If the waypoint is not in the navigation database, the temporary waypoint should be created and
inserted in the desired location in the route (as described in Section 3) before defining the search
pattern.
1. Display the RTE x LEGS page so that the search pattern can be inserted at the desired location in the route
by pressing [LEGS] and [NEXT] as required.
2. Move the waypoint entry to the desired location by pressing the appropriate LSK.
The MOD RTE x SQUARE 1/1 page is displayed. Press [NEXT] or [PREV] to select a different search
pattern. Modify the search pattern parameters as required, following the manual entry procedure described
previously.
3. Verify the search parameters, and arm the search by pressing the <ACTIVATE> and [EXEC] keys.
NOTE: If the off-route waypoint is made the TO WPT, executing the search pattern also results in
Direct-To
navigation to the search waypoint without an intercept course. If an intercept course is required,
return to the RTE LEGS page and setup the intercept course prior to pressing the [EXEC] key.
1 R
2 R
3 R
4 R
5 R
6 R
INACT DES+SAR 2/2
R E F I D
WPT04 RTE DISCON
>
R A D / D I S
---
T
/----
NM
<
SQUARE
ACT
HOLD
>
<
LADDER RADIAL-TO
>
<
SECTOR TACT DTO
>
<
FLY OVER DIRECT-TO
>
1 L
2 L
3 L
4 L
5 L
6 L
This page is printed under user's responsibility
and must not be retained for reference