OPERATOR’S
MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
Page
7-18
November 19, 2009
1. Delete the "<ACT>" approach by pressing LSK 1R.
All approaches and runways are displayed.
2. Select the desired approach (and transition) by pressing the appropriate right hand LSK(s).
NOTE: If the same approach is to be flown a second time, delete and reselect the existing approach, or
approach transition, by pressing LSK 1R or LSK 2R and then pressing the appropriate right hand
LSK(s).
3. Display the MOD RTE x LEGS 1/X page by pressing [LEGS].
The waypoints of the new approach procedure are separated from the TO WPT by a route discontinuity.
4. Initiate navigation to the first waypoint of the new approach procedure by direct-to navigation, with or without
an intercept, as required by the clearance.
5. Verify the course and distance of the new approach procedure legs, pressing [PREV] or [NEXT] as required.
6. Make the new approach procedure active by pressing [EXEC].
NOTE: EXECution of the new approach procedure causes all remaining waypoints of the current missed
approach procedure to be deleted, except the active waypoint. If automatic leg sequencing from the
active waypoint to the first waypoint of the new approach procedure is desired, simply close up the route
discontinuity by copying the first waypoint of the new approach procedure to the scratchpad and pressing
LSK
2L. Make the new route active by pressing [EXEC].
MODIFYING APPROACH PROCEDURES
To accommodate changes in approach clearances, new procedures can be selected at any time.
Display the ARRIVALS 1/1 page for the desired airport by pressing [DEP/ARR].
NOTE: The ARRIVALS 1/1 page for the destination airport will be displayed by default if the aircraft is more
than halfway to its destination. Otherwise, if the DEP/ARR INDEX 1/1 page is displayed, select the
desired arrival airport by pressing the appropriate <ARR> prompt (LSK 1R or LSK 2R).
1. Press the appropriate right LSK. Pressing LSK toggles the selection status between selected and not
selected.
The selected approach procedure (or portion thereof) is deleted. Repeat this process as required.
NOTE: Deleting the approach will re-display all approaches and runways. Deleting only the approach transition
results in display of only the transitions appropriate to the selected approach.
2. Select the new procedure(s) as described in previous sections.
3. Display the MOD RTE x LEGS 1/X page by pressing [LEGS], and verify the course and distance of the legs
of the modified approach procedure, pressing [PREV] or [NEXT] as required.
This page is printed under user's responsibility
and must not be retained for reference