OPERATOR’S
MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
Page 13-7
November 19, 2009
NOTE: It is also possible; for certain HF and V/UHF radios, to configure an external discrete which would inhibit
access to the dedicated radio’s FMS control pages. In such cases, FMS NOT IN CTRL will be displayed in
the field where the radio’s tuning information is normally displayed on this RADIO page. Access to the HF
and V/UHF dedicated radio pages is inhibited by removing the caret next to the radio’s name (as seen in
the example above at LSK3L and 4L).
When radio control is restored to the FMS for any of these radios, the HF and/or V/UHF’s the
settings/selections were made on the alternate control panel(s) will be reflected on the FMS.
The frequency becomes amber when unable to tune a radio.
The area of the RADIO 1/X page located between the preset/ident fields (e.g. just above the
are
reserved for special awareness information pertaining to the specific radio(s).
Additionally, this area will display the FMS commanded radio power status for the IFF transponders
(e.g. text showing “OFF” will be displayed in the special awareness field when the IFF power control is
selected to OFF).
Details pertaining to a radio’s specific special awareness field are captured in the dedicated radio’s
section.
VHF1 [1L]:
Access to the VHF1 radio page.
VHF2 [2L]:
Access to the VHF2 radio page.
VHF1 [1R]:
Display and modify the VHF active and standby frequencies/presets. Entry may be made to the
standby position only when a new value is in the scratchpad. If the scratchpad is empty it toggles active/standby
frequencies.
VHF2 [2R]:
Display and modify the VHF active and standby frequencies/presets. Entry may be made to the
standby position only when a new value is in the scratchpad. If the scratchpad is empty it toggles active/standby
frequencies.
NAV1 [3L]:
Access to the NAV1 radio page.
NAV2 [4L]:
Access to the NAV2 radio page.
NAV1 [3R]:
Display and modify the NAV active and standby frequencies/ident/preset. Entry may be made to the
standby position only when a new value is in the scratchpad. If the scratchpad is empty it toggles active/standby
frequencies.
When auto-tuning mode is active, an inverse video ‘A’ is displayed next to the active ident/preset. Auto-tuning
mode is entered by assigning “DELETE” (press the [CLR] key) to the NAV1 standby frequency. Returning to
manual tuning mode requires “DELETE” (press the [CLR] key) to be assigned to the NAV1 standby frequency or
swapping of the active and standby NAV1 frequencies.
NAV2 [4R]:
Display and modify the NAV active and standby frequencies/ident/ presets. Entry may be made to
the standby position only when a new value is in the scratchpad. If the scratchpad is empty it toggles
active/standby frequencies.
When auto-tuning mode is active, an inverse video ‘A’ is displayed next to the active ident/preset. Auto-tuning
mode is entered by assigning “DELETE” (press the [CLR] key) to the NAV2 standby frequency. Returning to
manual tuning mode requires [“DELETE” (press the [CLR] key) to be assigned to the NAV2 standby frequency or
swapping of the active and standby NAV2 frequencies.
ATCx [5L]:
Access to the ATC radio page.
This page is printed under user's responsibility
and must not be retained for reference