OPERATOR’S
MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
Page
11-81
November 19, 2009
C. At one minute from the CRP waypoint, the alert messages “CARP ALT NOT MET” or “CARP TAS NOT
MET”, and “NO CARP SOLUTION” are raised. If the situation is corrected prior to 10 seconds to CRP, then
the situation reverts to A or B; otherwise, “NO CARP SOLUTION” remains until the CARP procedure is
terminated.
Whilst “NO CARP SOLUTION” is displayed, the standard CARP advisories and the AT CARP remote
annunciator are disabled. This alert message may also be raised if not in the inertial navigation mode (e.g.
due to inertial sensors inputs being lost), or baro-altitude or baro-correction input is lost.
The “NO CARP SOLUTION” message will also be displayed if equipment failures preclude a valid CARP
solution computation and a valid offside FMS CARP solution is not available.
The “CARP XTK TOO LARGE” message will be displayed if the aircraft is flying the CARP procedure
between the CRP (Green Light) and XTE (Red Light) waypoints and the cross-track error is larger than half
the drop zone width, as was defined in the CARP PLAN 1/3 page. CARP advisory messages and remote
annunciators are provided as usual, allowing the operation to continue.
EXIT FROM CARP
The FMS will automatically terminate the CARP procedure once the ESC waypoint is sequenced. It is also
possible to exit CARP with a direct-to or close up operation on the LEGS page and then pressing EXEC. The
procedure may also be directly deleted from the flight plan if any of its waypoints is not the active waypoint.
CARP RE-ENTRY
To abort and re-enter a CARP procedure, it is required to perform the following steps:
1. Exit the last CARP procedure (as indicated above). The EXEC key does not have to be pressed.
2. Re-initiate the CARP procedure at the first waypoint location of the flight plan. Refer to Section 11,
INITIATION OF A CARP PROCEDURE for more details.
3. The FMS will retain all the previously entered CARP PLAN values, requiring only the EXEC key to be
pressed.
This page is printed under user's responsibility
and must not be retained for reference