OPERATOR’S
MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
Page
11-21
November 19, 2009
Display the HOVER 1/1 page by pressing:
[INIT REF],<DES+SAR> or <TACTICAL>,<HOVER> or
[INIT REF],<WPT DATA>,<DES+SAR> or <TACTICAL>,<HOVER> or
[INIT REF],<WPT LISTS>,<PREDEF WPT>,select waypoint identifier or coordinates,<DES+SAR> or
<TACTICAL>,<HOVER> or
[INIT REF],<WPT LISTS>,<DMAP WPT>,select DMAP waypoint
identifier,<DES+SAR> or
<TACTICAL>,<HOVER> or
[INIT REF],<WPT LISTS>,<PREDEF WPT>,[NEXT],<DES+SAR> or <TACTICAL>,<HOVER> or
[INIT REF],<MARK ON TOP>,<DES+SAR> or <TACTICAL>,<HOVER> or
[MARK] {if CFG KEY 2 configured to MARK},<DES+SAR> or <TACTICAL>, <HOVER> or
{if FTDN command of IFDS is sent}
Unless the entry is made from the PREDEF WPT 2/2 page, enter or designate the Hover (MRK) point using LSK
1L or LSK 1R on the HOVER 1/1 page. The identifier (LSK 1L) or the coordinates (LSK 1R) of a waypoint can
be changed as long as there is no hover procedure defined in the active route.
If the system wind is not available, the wind parameters can be entered manually on the PROGRESS 1/4 page.
Activate the procedure using the ACTIVATE prompt on LSK 6R. At this point it is still possible to change the
MRK point if needed. Otherwise press [EXEC] to insert the TDN and MRK waypoints in the flight plan and
initiate the guidance.
NOTE: The Hover height is entered on the AFCS and displayed on the CMA-9000 FMS HOVER page.
One of the following actions can be used to exit the hover procedure:
•
Initiating another hover procedure.
•
Initiating a Direct-To a waypoint procedure.
•
Cancelling the route.
1 R
2 R
3 R
4 R
5 R
6 R
_ _
HOVER 1/1
WPT01
M A R K O N T O P P O S
N 4 0
o
0 9 . 6 1 W 0 8 9
o
2 0 . 2 7
R A D A L T H O V E R H E I G H T
2 5 6 0
F T
8 0
F T
T R U E W I N D V E L O C I T I E S
0 2 0
T
/ 4 5
K T
V X
+ 2 5 . 5
K T
V Y
+ 2 5 . 5
K T
<
CANCEL
ACTIVATE
>
1 L
2 L
3 L
4 L
5 L
6 L
This page is printed under user's responsibility
and must not be retained for reference