ESTechnical Reflow Oven Controller Full Upgrade Kit for T962A
41 of 50
solder paste and components used on your PCB(s)
Save these profile settings and make a note of the profile number in your project
documentation for the PCB
Production of PCBs
Once you have set up a reflow profile for your PCB design:
Prepare PCBs with solder paste and components
Select the correct profile for the board design
Place PCB(s) in the reflow oven drawer
Run the cycle
Remove soldered PCB(s) once the oven has cooled
Repeat as needed
Menu Layout & navigation
Navigate the menu using the keypad keys
<
&
>
to move through the menu items, press
Ok
to select
a menu item. Pressing
Back
will return you to the previous level of the menu.
The menu is organised as follows:
Menu layout
Start Cycle
Edit Profile
Ramp up rate
Soak temp
Soak time
Peak temp
Peak time
Ramp down rate
Load Profile
Choose profile number
Save Profile
Choose profile number
Fan Settings
Idle speed
Save
Factory Reset
Reflow Profile Testing
The ESTechnical Reflow Oven Controller is equipped to make setting up reflow profiles easy – it is
essential to carry out this testing correctly to ensure correct profile settings are used for your
board(s).
Profile testing should be carried out for each design of board to be soldered.
