Esta CTM32, Instruction Manual

Page: 5 / 43

5
INSTALLATION
It is advisable to clean the inside of the absorption refrigerator with lukewarm water using a
mild detergent, and then to dry it thoroughly prior to use.
The temperature in the appliance will depend on:
The temperature in the room
The frequency and duration of periods when the door is open.
How many items are in the fridge
It may therefore be necessary to adjust the thermostat from time to time.
The refrigeration system of the cabinet is designed to operate with the cabinet located on a
flat surface. Avoid tilting the cabinet side.
If the cabinet must be tilted on an angle for handling or moving purposes, allow it to sit in an
upright position 20 to 30 minutes prior to plugging it in and starting the cooling of the storage
compartment.
Grounding plug and socket should be provided in accordance with local regulations. The cable-size
should meet the refrigerator’s requirements. The unit must be connected to proper electrical
network, which is shown on the nameplate, through an omnipoplar circuit-breaker. To assure the
proper function of the refrigerator, please observe the following recommended.
1.
To ensure the circulation, the unit should be kept at 2 cm, away from the wall.
2. Locate the unit away from direct sunlight. This will enable you to obtain the best performance
and save energy.
3. Under no circumstances should the top grid be covered by any objest. It will preclude the warm
air from circulating.
Installation Figure