Essilor Neksia, User Manual

Page: 79 / 84

This device complies with the limits imposed by Part 15 of the FCC rule. Its use meets the following conditions: (1) this device must not
cause interference and (2) must accept interference from external sources, notably that liable to cause malfunctions.
In accordance with the requirements of FCC rules, any modification made to this equipment which is not expressly approved by ESSILOR
INTERNATIONAL would nullify the user's right to use this device.
This equipment has been tested and is deemed compliant with the limits imposed for Class-B digital devices according to Part 15 of the FCC
rule. Those limits are set so as to ensure reasonable protection against interference in a residential environment. This device generates,
uses and may emit radio frequency energy capable of interfering with radio communications if the device is not installed and used in strict
accordance with the manufacturer's instructions. However, nothing guarantees the absence of interference under particular conditions. If
this device generates interference with radio or TV reception (this can be confirmed by turning it off then on again), the user can eliminate
this interference by one or more of the following methods:
• swivel or move the affected receiver or its receiving antenna;
• move the device away from the affected receiver;
• plug the device into a circuit other than the circuit supplying the affected receiver;
• ask for the assistance of the retailer or a qualified radio/television technician.
4. C
OPYRIGHT
Copyright © 2013 Essilor - Original Manual Translation
All rights reserved. All reproduction of the content of this document, whether in part or as a whole, for the purpose of its publication or
dissemination by any means and in any format whatsoever, even free of charge, is strictly prohibited without Essilor's prior written consent.
5. M
ATERIALS AND PRODUCTS
The aim of all edgers is to obtain a final shape on a lens, by removal of material. This process generates dust whose type depends on the
lens and the materials used.
The materials used for coating the Essilor wheel and consumed during its use are not toxic or allergenic. Nevertheless, users must check
that the ground materials are not toxic.
The edger limits the amount of dust significantly due to its integrated devices: operation in an enclosed machine and edging in a wet
environment.
Do not place this machine in a dusty environment, in a room where the temperature is too high or too low, or in a wet place.
6. S
AFETY INSTRUCTIONS
:
All mechanical or electronic adjustments and electrical maintenance must be carried out by a customer service technician approved by
Essilor.
The use of an accessory or a cable other than those recommended in this manual can be dangerous for users.
Keep the power cables and the solenoid valve/pump cables away from sources of heat, sharp objects and grease.
Check the power cable regularly; if damaged, have it replaced by an approved repairer.
Do not use your system in any way other than described in this document. Otherwise, the protection provided by the device could be
compromised.
Never try to modify or dismantle this product yourself. In addition to the fact that you are likely to damage the instrument, you can also
injure yourself.
Your edger must be carefully maintained, in accordance with the instructions detailed in this document.
U
SER
M
ANUAL
> G
ENERAL INFORMATION
79
Neksia > v1.0 - 02.14