Device functions
The scope has a number of measurement and interaction options. Please note that some
functions can only be run in combination with the
essent
im
app (the note "App" is added as
an annotation for these features).
Button
The button has three functions:
- Switch on / switch off
- Reset
- User interaction with the scope
Switch on / switch off
The scope can be switched on and off by pressing the centrally located button. To switch on, a
short press of the button is sufficient, to switch off the button must be pressed for 6 to 7
seconds.
The scope switches itself off at low battery level by itself to prevent a deep discharge.
Note
A er switching off due to a low battery level, the scope
no longer can be activated through pushing the button, but only by
charge.
When switched on, the green LED flashes several times;
When switched off, the red LED flashes several times.
Reset
By pressing the button for 12.5 seconds or longer, a reset is performed - the scope is reset and
restarted.
Note
Measured data from the memory is not lost during a reset,
individual settings can be lost.
User interaction with the scope
In the switched-on mode, pressing the button briefly will result in an event which is sent via
Bluetooth. In the essent
im
apps, an interaction with the scope can thus be determined. At the
same time, corresponding windows open and commands can be executed. When manually
reading out stored data, the button on the scope must be briefly pressed once to start the
transmission.
Note
Details can be found in the description of the app (for example, "bind scope",
"data fetch "or “pop-ups”).
12
user manual scope - version 1.1
