PIR Coach Lantern
5543J
27/08/2015
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
Recycling advice
Safety information
Do not use solvents or abrasive cleaners as these could damage the finish.
Glass - Remove and wash in warm water or just use a damp cloth. Do not use abrasive materials.
Do not clean the units with a pressure washer.
This bulb is protected by a shade. This part must be replaced immediately should the shade
become cracked or damaged. This fitting must not be used without the shade in place.
Care and cleaning
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Fitting/replacing bulbs
When changing a bulb, always switch off at the mains and allow the bulb to cool before handling.
Dispose of used bulbs carefully.
Do not exceed the wattage stated from that indicated on the fitting.
To access the bulb, remove the decorative nuts on top of the shade, and lift off the top. Set aside.
Relocate the shade top over the screws and secure in place with the screws.
Replace Cracked
Shade
Please note this product is fitted with
a daylight sensor, therefore it will only
activate once the ambient light level
drops below 10 Lux.
Duration the bulb stays on is
adjustable by turning ‘Time’ screw
Detection range can be adjusted
by turning ‘Sens’ screw
Base of product
Adjustable 6 - 12 metres
TIME
SENS
3m
6m
8m
12m
120˚
