Essemtec Paraquda, Startup & Safety Manual

Page: 94 / 196

Operating of the Machine
4-22
© Essemtec AG Paraquda Startup & Safety
000
00
03/
11
/
N
ov
emb
er 4
, 2
01
4
4.3.5 Handle hyQ Feeders (Tape&Reel)
Feeder Control Panel
Each feeder lane has two LEDs (green / red) to
indicate the status and one button for
controlling.
Using the button, the following functions are
possible:
•
During setup, pressing once: the cover tape
transport roller will rotate pulsed for
approximately 20 seconds to thread the
cover tape.
•
During setup, pressing for a few seconds:
tape and cover tape will be fed.
•
Setup done (feeder kitted), pressing once:
tape and cover tape will be fed for 4 mm.
For standard status indication of the LEDs,
please use the online help in ePlace (Produce -
Pick Control). If red and green blinks
alternatively, the feeder is powered but did not
get an address.
Detect empty Feeder Lane
A continuous red light on the Feeder LED can
indicate an empty feeder lane.
Note: A continuous red light could also
indicate a bad pick position (X/Y/height).
After a certain amount of faulty repicks
(default 3), the LED turns to continuous
red.