ESP APWIFIDS2, Quick Start Manual, Page: 1 / 4

x 1
Power Adapter DC Power Cable
x 1
Black
Red
Dry/Wet Contact Cable
x 2
Black
Black
Screw Pack
x 1
Screw Pack
x 1
x 1
Quick Start Guide
Door Station &
MicroSD
x 1
Wall-Bracket
x 1
HARDWARE OVERVIEW
I/O Pin Connector
1.B2/B1: Dry Contact I/O for door lock
2. V-/V+: Power Input I/O*
3. RD+/RD-/TD+/TD-: Ethernet Cable I/O*
4. C2/C1: Dry Contact I/O for door chime
Reset Button
Memory Card Slot
Push Button
Microphone
Light sensor
*Power input jack can be safely connected
with DC 9~48V power cable in any polarity.
AC power input not supported.
*Ethernet cable not included in the package.
Full HD Camera
Speaker
3
1. Fasten the wall-mount bracket to the wall by using 2pcs screws provided.
2. Connect power cable to the power input I/O pins by through the water-resistant cover.
3. Place the device on the wall-mount bracket.
4. Apply power to the device
1. The SD card will be pre-installed, if upgrading the SD card:
2. Slide the metal housing down and camera up to seperate the camera with back cover.
3. Remove the rubber cover of the SD Card slot on the left side of the camera.
4. Insert the SD Card and put back the rubber cover.
INSTALLATION
2 1 3 4
SD
Note:
Battery AA 1.5V
x 3 x 1
Door Chime
4 2 1
QUICK START GUIDE
APWIFIDS2 APWIFIDSBLK2
INSTALLATION OVERVIEW
Prior to installation, please ensure that a strong and stable Wi-Fi signal
can be achieved at the installation position. A 2.4GHz Wi-Fi connection is required
For additional guidance refer to the notes in the back of this guide.
Power cable
Water-resistant
cover
1 2
4. After supplying power, the boot up process will begin (around 2 minutes),
the push button LED will flash once the boot up process is complete and registration ready
(check connectors and power source if red LED do not come on).
CONTENT