7
En
gl
is
h
Precautions for use
o
Place the unit in a stable location near the audio system that you
will use with it.
o
Do not install this unit in a location that could become hot. This
includes places that are exposed to direct sunlight or near a radia-
tor, heater, stove or other heating equipment. Moreover, do not
place it on top of another amplifier or equipment that generates
heat.
o
Avoid locations that are subject to vibrations or exposed to exces-
sive dust, cold or moisture.
o
In order to enable good heat dissipation, leave at least 20 cm (8
"
)
between this unit and walls and other equipment when installing
it. If you put it in a rack, take precautions to prevent overheating
by leaving at least 20 cm (8
"
) open above the top of the unit and
at least 10 cm (4
"
) open behind it. Failure to provide these gaps
could cause heat to build up inside and result in fire.
o
Do not install the unit face up or on its side.
o
Do not place anything, not even CDs, CD-Rs, LP records or cassette
tapes, on top of the unit. Do not put cloth on top of the unit or
place the unit on top of bedding or thick carpet.
o
Do not move the unit during use.
o
Be careful to avoid injury when moving the unit due to its weight.
Have someone help you move it if necessary.
o
The voltage supplied to the unit should match the voltage printed
on the rear panel. If you are in any doubt regarding this matter,
consult an electrician.
o
Do not open the body of the unit as this might result in damage
to the circuitry or cause electric shock. If a foreign object should
get into the unit, contact your dealer.
o
When removing the power plug from the wall outlet, always pull
directly on the plug; never yank on the cord.
Maintenance
Use a soft dry cloth to wipe the surface of the unit clean.
For stubborn smudges, use a damp cloth that has been thoroughly
wrung out to remove excess moisture.
V
For safety, disconnect the power plug from the out-
let before cleaning.
o
Never spray liquid directly on this unit.
o
Do not use chemically-treated wipes, thinner or similar substances
because they could damage the surface of the unit.
o
Avoid allowing rubber or plastic materials to touch the unit for
long periods of time because they could damage the cabinet.
Note about pinpoint feet
High-precision metal pinpoint feet are attached firmly to the bottom
plate of this unit.
Chassis
Pinpoint foot (metal)
Foot-stand (metal)
Screws that attach
foot-stand
The stands for these feet are loose, but when the unit is placed in
position, it is supported by these pinpoint feet, which will effectively
disperse vibrations.
o
Apply the included felt pads to the bottoms of the foot-stands to
avoid scratching the surface where the unit is placed.
Summary of Contents for F-03A
