PSM 10/12/15 Series Installation manual
Esoltech AB, the battery company
May 1, 2019
28
•
Build the cable / peel off the insulation (approx. 1.0 cm)
•
Insert the cable into the terminal block* as indicated (figure below)
•
Plug in the terminal block and fasten the screws (flat-blade 2mm)
Note*: an alternative terminal block (PLTB2.5-BF-SP) with a push-release mechanism
instead of fastening bolt may also be found in the package
Please consult electrician for the AC power cabling.
5.3 Cable gland
Check all the external cabling before tightening the cable gland.
Make sure no tension is built when fastening the cable gland.
2 2 0 V A C
L
N
P E
